High Head Dewatering Pump

Features Application
1. Semi-open, High Chrome Iron impeller with replaceable/adjustable High Chrome Iron Wear rings, increases wear Resistance, when pumpage contains abrasive particles. 1. Commercial, industrial dewatering and construction site drainage.
2. Double inside mechanical seals with silicon carbide faces, (both top and bottom) running in an oil filled chamber and further protected by a lip seal running against a replaceable, 420 stainless steel shaft sleeve, provides for the most durable seal design available. 2. Effluent transfer
3. Highly efficient, continuous duty air filled, copper wound motor with class B or F insulation, minimizes the cost of operation 3. Decorative waterfalls and fountains
4. Built in thermal & amperage sensing, protector prevents motor failure due to overloading or accidental run - dry conditions. 4. Raw water supply from rivers or lakes
5. Double shielded, permanently lubricated, high temperature C3 ball bearings fated for a B-10 life of 60,000 hours, extend operational life.  
6. Top discharge, flow-thru design enables operation at low water levels for extended periods  
LH-W Pump

Performance Curves
Specifications Standard Options
Discharge Size 2", 4" Npt (50, 100mm ) Available in all Stainless Steel
Horsepower Range 7.5 - 40Hp.
Performance Range
  Capacity 30 - 364 Gpm (.11 - 1.37cubic metre/ min)
Head 70 - 400Ft. - 100 Ft. (21 - 122 m)
Maximum Water Temperature 104F. (40C)
Materials of Construction
  Casing Cast Iron
Impeller High Chrome Cast Iron
Shaft 420 Stainless Steel
Motor Frame Cast Iron
Fastners 304 Stainless Steel
Mechanical Seal
  Upper Seal Silicon Carbide / Carbon
Lower Seal Silicon Carbide / Silicon Carbide
Elastomers NBR (Nitril Buna Rubber)
Impeller Type Enclosed,two stage, solids handling
Solid Handling Capability Screen Size
Motor Nomenclature
  Type, Speed, Hz Air Filled, 3600 Rpm, 60 Hz.
Voltage, Phase 208/230/460/575 V.., 3 Phase
Insulation Class B, F (40 Hp.)
Bearings Pre-lubricated, Double Shielded
Accessories Submersible Power Cable 49' (15 m) Length as Required
Operational Mode Manual